Tv B Gone Kit Instructions. The button should sit flat against the circuit board. Strip the ends of the wires so there is about about 1/4 exposed.
tronixstuff Kit Review adafruit industries TVBGone from tronixstuff.blogspot.com
Learn how to solder with tons of tutorials! Press the button once (no need to hold the button down). Repeat for all four legs.
Don't Forget To Learn How To Use Your Multimeter Too!
Line up the metal legs with the holes in the circuit board and snap it in. Tools and batteries are not. This version can be used in both north american/asia as well as europe/uk areas (basically, the whole world)!
The Button Should Sit Flat Against The Circuit Board.
Point it at a tv set. Keep pointing it at the tv until the tv turns off (which may take up to 69 seconds, but most tvs will respond within the first few seconds). It is a 'disruptive technology device' designed to switch off annoying and unnecessary televisions.
Next Grab The Battery Holder And Clip The Leads Short, To Maybe 1.5 (4Cm) Long.
Keep pointing it at the tv until the tv turns off (which may take up to 69 seconds, but most tvs will respond within the first few seconds). The solder points should be clean and shiny. Begin by trimming the leads on the battery holder until there is only about a quarter of the wire remaining.
Solder Them In Parallel, And Cut The Excess As Shown.
Strip the ends of the wires so there is about about 1/4 exposed. Tools and batteries are not included. You can select which zone you want during kit assembly.
Press The Button Once (No Need To Hold The Button Down).
Learn how to solder with tons of tutorials! Strip the ends of the wire off so that there's a short section without insulation. Solder the rest of the points then clip short the legs of the oscillator.
